Efest SODA Dual-Bay Battery Charger

vendor-unknown

  • $12.95



The Efest Soda Charger features dual battery bays, over-voltage and over-discharge protection, auto cut-off voltage, multi-type battery support, and reliable design. It's reliable design will ensure quick and consistent charging of all supported types of batteries. Charge two batteries independently while simultaneously monitor both batteries. Select between rapid charge mode if you are short on time or use normal charge mode. The sliders for the battery work smoothly and can accept batteries from 30mm to 71mm


Battery Types:


On top of the charger is a list of supported battery sizes, but it does include some batteries that are too small to charge on the charger, and it is missing a list with current settings. Supported types are laid out below.





The charger can handle 70 mm long batteries including flat top cells. Because the 0.5A current is more like 0.6A, the charger is not that good for non-IMR 16340 or 10440 batteries. Only use IMR 16340 or 10440 with this charger.
Note: Using to high charge current will not make the batteries explode, but will reduce lifetime of the batteries.


Features:


  • Model: Efest Soda Dual Charger
  • Input: AC 100 ~ 240V (50/60Hz)
  • Modes: Rapid charger or normal charger
  • Auto Recharge: 3.9 ± 0.15V
  • Over-Voltage Protection
  • Over-Discharging Protection
  • Short-Circuit Protection
  • Reverse Polarity Protection
  • Auto cut-off: 4.23 ± 0.05V
  • Standby: <20mA
  • CV cut-off: < 10% max current
  • Maximum Output: 1A
  • Operation Temperature -40℃~+70℃
  • Storage Temperature 0℃~40℃
  • Plug: American


Measurements:

  • When not connected to power it will discharges with up to 0.4mA.
  • When power is connected with a full battery, the charger will discharge with 0.04mA
  • Below 0.4 volt the charger does not detect a battery and does not charge.
  • Between 0.4 and 2.9 volt it chargers with up to 50mA current (Led is red).
  • Above 2.9 volt it will charge with full current.
  • It will restart charging, if the voltage drops below 4.14 volt.
  • It will not restart charging on reinsertion of the battery or power cycling.
  • It is possible to switch current during charge.
  • The channels on the charger are independent, i.e. there are small differences between them.


Additional Information

Weight 0.5 lbs
Dimensions 7 x 4 x 1.5 in



This is a genuine Efest product, obtained directly from Efest.

Efest Charges And Batteries